Problem with Euro Sequencer Cv out 1 and some other issues.

Discussion and support for users and builders of Oakley Sound musical products.

Moderators: Kent, Synthbuilder

User avatar
Synthbuilder
Super Deluxe Wiggler
Posts: 3238
Joined: Tue Mar 24, 2009 9:12 am
Location: Cumbria, UK

Re: Problem with Euro Sequencer Cv out 1 and some other issues.

Post by Synthbuilder »

djthopa wrote: Sat Jul 04, 2020 4:38 amI have notest that i used NPN 45v BC550CBU, but i also have BC550BB 1G.
Both BC550B or BC550C can be used in this project.
User avatar
djthopa
Super Deluxe Wiggler
Posts: 1951
Joined: Thu Mar 22, 2012 5:48 pm
Location: Somewhere between a nappy and a wire

Re: Problem with Euro Sequencer Cv out 1 and some other issues.

Post by djthopa »

Hi Tony,

Its was the same mistake from the controller board.......resistor networks had pin1 inverted.

Manage to desolder both witout causing damage to the board or the resistor network, soldered them back and its all working how its meant too.

Thanks a lot for your support and for helping me out nail this one down....nearly gave up there!

Have a good weekend and thanks again :) :miley:

Ps: I’m going to call this module Black Phillip :zombie:
Post Reply

Return to “Oakley Sound Systems”