Super Sixteen build support thread

Creator of of the Super Sixteen Sequencer and based in San Francisco. This is a DIY and Finished Good product for Eurorack.
Post Reply
Learning to Wiggle
Posts: 11
Joined: Fri Jan 06, 2023 11:34 am

Re: Super Sixteen build support thread

Post by zqz »

extralifedisco wrote: Tue Jan 17, 2023 7:14 pm
zqz wrote: Tue Jan 17, 2023 5:12 am Thank you.
did not help, keeps jumping value
Interesting. I suspect there is an issue with the power supply you are running it on (high noise). One other thing you can try is to set the display brightness to level 4 (instead of default 5). Enter calibrate mode (SHIFT+14), then press button 9 (tempo) and adjust brightness using the DATA encoder. When set to 4, the display/LED multiplexing will run in cycles of 4 so that all the potentiometer reads should always be synced to same part of the multiplexing cycle.
pots jumps if touch without plastic knob. with knobs it works good, thanks for change threshold! Perfect!
Post Reply

Return to “Extralife Instruments”