Building a VCO1 as designed by Thomas Henry

From circuitbending to homebrew stompboxes & synths, keep the DIY spirit alive!

Moderators: Kent, luketeaford, Joe.

Post Reply
User avatar
Learning to Wiggle
Posts: 14
Joined: Wed Aug 29, 2018 7:43 am
Location: Germany

Building a VCO1 as designed by Thomas Henry

Post by mlatu » Sat Oct 06, 2018 4:21 am

So, I finally got the parts, after designing the PCB Layout using KiCAD.

Thought I would share pictures of the build process.

PCB is done (i.e. prepared), doesn't look pretty, next time I'll try the toner heat transfer method.
I could also try and dye the PCB to get it coloured more evenly, I guess.

I added about two dozen jumper wires, more tomorrow.

Post Reply

Return to “Music Tech DIY”